Person:

Gordon, Roy

A highly stable phosphonate‐functionalized anthraquinone is introduced as the redox‐active material in a negative potential electrolyte (negolyte) for aqueous redox flow batteries operating at nearly neutral pH. The design and synthesis of 2,6‐DPPEAQ, (((9,10‐dioxo‐9,10‐dihydroanthracene‐2,6‐diyl)bis(oxy))bis(propane‐3,1‐diyl))bis(phosphonic acid), which has a high solubility at pH 9 and above, is described. Chemical stability studies demonstrate high stability at both pH 9 and 12. By pairing 2,6‐DPPEAQ with a potassium ferri/ferrocyanide positive electrolyte across an inexpensive, nonfluorinated permselective polymer membrane, this near‐neutral quinone flow battery exhibits an open‐circuit voltage of 1.0 V and a capacity fade rate of 0.00036% per cycle and 0.014% per day, which is the lowest ever reported for any flow battery in the absence of rebalancing processes. It is further demonstrated that the negolyte pH drifts upward upon atmospheric oxygen penetration but, when oxygen is excluded, oscillates reversibly between 9 and 12 during cycling. These results enhance the suitability of aqueous‐soluble redox‐active organics for use in large‐scale energy storage, potentially enabling massive penetration of intermittent renewable electricity.

Ferrocene (Fc) is one of the very limited organic catholyte options for aqueous organic flow batteries (AOFBs), a potential electrochemical energy storage solution to the intermittency of renewable electricity. Commercially available Fc derivatives are barely soluble in water, while existing methods for making water‐soluble Fc derivatives by appending hydrophilic or charged moieties are tedious and time‐consuming, with low yields. Here, a strategy was developed based on host–guest inclusion to acquire water‐soluble Fc‐based catholytes by simply mixing Fc derivatives with β‐cyclodextrins (β‐CDs) in water. Factors determining the stability and the electrochemical behavior of the inclusion complexes were identified. When adopted in a neutral pH AOFB, the origin of capacity loss was identified to be a chemical degradation caused by the nucleophilic attack on the center FeIII atom of the oxidized Fc derivatives. By limiting the state of charge, a low capacity fade rate of 0.0073 % h−1 (or 0.0020 % per cycle) was achieved. The proposed strategy may be extended to other families of electrochemically active water‐insoluble organic compounds, bringing more electrolyte options for practical AOFB applications.

A highly stable phosphonate‐functionalized viologen is introduced as the redox‐active material in a negative potential electrolyte for aqueous redox flow batteries (ARFBs) operating at nearly neutral pH. The solubility is 1.23 m and the reduction potential is the lowest of any substituted viologen utilized in a flow battery, reaching −0.462 V versus SHE at pH = 9. The negative charges in both the oxidized and the reduced states of 1,1′‐bis(3‐phosphonopropyl)‐[4,4′‐bipyridine]‐1,1′‐diium dibromide (BPP−Vi) effect low permeability in cation exchange membranes and suppress a bimolecular mechanism of viologen decomposition. A flow battery pairing BPP−Vi with a ferrocyanide‐based positive potential electrolyte across an inexpensive, non‐fluorinated cation exchange membrane at pH = 9 exhibits an open‐circuit voltage of 0.9 V and a capacity fade rate of 0.016% per day or 0.00069% per cycle. Overcharging leads to viologen decomposition, causing irreversible capacity fade. This work introduces extremely stable, extremely low‐permeating and low reduction potential redox active materials into near neutral ARFBs.

Microbatteries with safe, non-corrosive electrolyte chemistries can have an immediate positive impact on modern life applications, such as ingestible electronic pills and system-on-chip bioelectronics. Here a safe, non-corrosive and non-flammable microbattery is reported. A natural agarose hydrogel is the electrolyte-supporting matrix, and organic and organometallic molecules are the redox-active species. This device can safely meet the needs of ingestible medical microdevices as a primary battery. Additionally, this redox gel system can be used as a secondary battery for on-chip electronics applications, potentially enabling safe and cost-effective small-scale energy storage.

Nanowires have promising applications as photodetectors with superior ability to tune absorption with morphology. Despite their high optical absorption, the quantum efficiencies of these nanowire photodetectors remain low due to difficulties in fabricating a shallow junction using traditional doping methods. As an alternative, we report non-conventional radial heterojunction photodiodes obtained by conformal coating of indium oxide layer on silicon nanowire arrays. The indium oxide layer has a high work function which induces a strong inversion in the silicon nanowire and creates a virtual p-n junction. The resulting nanowire photodetectors show efficient carrier separation and collection leading to an improvement of quantum efficiency up to 0.2. In addition, by controlling the nanowire radii, the spectral response of the In2O3/Si nanowire photodetectors are tuned over several visible light wavelengths, creating a multispectral detector. Our approach is promising for the development of highly-efficient wavelength selective photodetectors.

The oxide and sulfide of divalent tin show considerable promise for sustainable thin-film optoelectronics, as transparent conducting and light absorbing p-type layers, respectively. Chemical vapor deposition (CVD) and atomic layer deposition (ALD) provide attractive routes to these layers. The literature on volatile tin(II) compounds used as CVD or ALD precursors shows that new compounds can provide different growth rates, film morphologies, preferred crystallographic orientations, and other material properties. We report here the synthesis and characterization of a new liquid tin(II) precursor, bis(N, N′-diisopropylformamidinato)tin(II) (1), which is effective in ALD of SnS in combination with H2S between 65 and 180 °C. Like other highly reactive tin(II) precursors, the growth per cycle linearly decreases from 0.82 Å/cycle at 65 °C to 0.4 Å/cycle at 180 °C. This is obviously different from the case of previously reported SnS ALD using bis(2,4-pentanedionato)tin(II), Sn(acac)2, and H2S; films grow at 0.22-0.24 Å/cycle almost independent of the substrate temperature (125- 225 °C, J. Phys. Chem. C 2010, 114, 17597). Quartz crystal microbalance (QCM) experiments for SnS ALD using 1 at 80, 120, and 160 °C were carried out to study the linear decrease of the growth per cycle with increasing substrate temperature. Based on these QCM studies, although the mechanism of chemisorption—loss of one ligand or two—can be manipulated by changing the exposure of 1, the purging time, or the temperature, only the temperature changes the growth per cycle. We, therefore, attribute the decreasing growth per cycle with increasing temperature to a decreasing surface thiol density. Photovoltaic devices prepared from 1-derived SnS have similar performance to the best devices prepared from other precursors, and the device yield and replicability of J-V properties are substantially increased by using 1.

Monolithically integrated solar flow batteries (SFBs) hold promise as compact stand‐alone energy systems for off‐grid solar electrification. Although considerable research is devoted to studying and improving the round‐trip efficiency of SFBs, little attention is paid to the device lifetime. Herein, a neutral pH aqueous electrolyte SFB with robust organic redox couples and inexpensive silicon‐based photoelectrodes is demonstrated. Enabled by the excellent stability of both electrolytes and protected photoelectrodes, this SFB device exhibits not only unprecedented stable continuous cycling performance over 200 h but also a capacity utilization rate higher than 80%. Moreover, through comprehensive study on the working mechanisms of SFBs, a new theory based on instantaneous solar‐to‐output electricity efficiency toward more optimized device design is developed and a significantly improved solar‐to‐output electricity efficiency of 5.4% from single‐junction silicon photoelectrodes is realized. The design principles presented in this work for extending device lifetime and boosting round trip energy efficiency will make SFBs more competitive for off‐grid applications.

Quinone–hydroquinone pairs have been proposed as biologically-inspired, low-cost redox couples for organic electrolytes for electrical energy storage, particularly in aqueous redox flow batteries. In their oxidized form, quinones are electrophiles that can react with the nucleophilic water solvent resulting in loss of active electrolyte. Here we study two mechanisms of nucleophilic addition of water, one reversible and one irreversible, that limit quinone performance in practical flow batteries. Using a combination of density functional theory and semi-empirical calculations, we have quantified the source of the instability of quinones in water, and explored the relationships between chemical structure, electrochemical reduction potential, and decomposition or instability mechanisms. The importance of these mechanisms was further verified through experimental characterization of a family of alizarin-derived quinones. Finally, ∼140 000 prospective quinone pairs (over 1 000 000 calculations including decomposition products) were analyzed in a virtual screening using the learned design principles. Our conclusions suggest that numerous low reduction potential molecules are stable with respect to nucleophilic addition, but promising high reduction potential molecules are much rarer. This latter fact suggests the existence of a stability cliff for this family of quinone-based organic molecules, which challenges the development of all-quinone aqueous redox flow batteries.

Water‐soluble redox‐active organic molecules have attracted extensive attention as electrical energy storage alternatives to redox‐active metals that are low in abundance and high in cost. Here an aqueous zinc–organic hybrid redox flow battery (RFB) is reported with a positive electrolyte comprising a functionalized 1,4‐hydroquinone bearing four (dimethylamino)methyl groups dissolved in sulfuric acid. By utilizing a three‐electrolyte, two‐membrane configuration this acidic positive electrolyte is effectively paired with an alkaline negative electrolyte comprising a Zn/[Zn(OH)4]2− redox couple and a hybrid RFB is operated at a high operating voltage of 2.0 V. It is shown that the electrochemical reversibility and kinetics of the organic redox species can be enhanced by an electrocatalyst, leading to a cyclic voltammetry peak separation as low as 35 mV and enabling an enhanced rate capability.