Person:

Nazarian, Ara

Objectives: This study aims to assess the correlation of CT-based structural rigidity analysis with mechanically determined axial rigidity in normal and metabolically diseased rat bone. Methods: A total of 30 rats were divided equally into normal, ovariectomized, and partially nephrectomized groups. Cortical and trabecular bone segments from each animal underwent micro-CT to assess their average and minimum axial rigidities using structural rigidity analysis. Following imaging, all specimens were subjected to uniaxial compression and assessment of mechanically-derived axial rigidity. Results: The average structural rigidity-based axial rigidity was well correlated with the average mechanically-derived axial rigidity results (R(^2) = 0.74). This correlation improved significantly (p < 0.0001) when the CT-based Structural Rigidity Analysis (CTRA) minimum axial rigidity was correlated to the mechanically-derived minimum axial rigidity results (R(^2) = 0.84). Tests of slopes in the mixed model regression analysis indicated a significantly steeper slope for the average axial rigidity compared with the minimum axial rigidity (p = 0.028) and a significant difference in the intercepts (p = 0.022). The CTRA average and minimum axial rigidities were correlated with the mechanically-derived average and minimum axial rigidities using paired t-test analysis (p = 0.37 and p = 0.18, respectively). Conclusions: In summary, the results of this study suggest that structural rigidity analysis of micro-CT data can be used to accurately and quantitatively measure the axial rigidity of bones with metabolic pathologies in an experimental rat model. It appears that minimum axial rigidity is a better model for measuring bone rigidity than average axial rigidity.

Objectives: Cadaveric models of the shoulder evaluate discrete motion segments using the glenohumeral joint in isolation over a defined trajectory. The aim of this study was to design, manufacture and validate a robotic system to accurately create three-dimensional movement of the upper body and capture it using high-speed motion cameras. Methods: In particular, we intended to use the robotic system to simulate the normal throwing motion in an intact cadaver. The robotic system consists of a lower frame (to move the torso) and an upper frame (to move an arm) using seven actuators. The actuators accurately reproduced planned trajectories. The marker setup used for motion capture was able to determine the six degrees of freedom of all involved joints during the planned motion of the end effector. Results: The testing system demonstrated high precision and accuracy based on the expected versus observed displacements of individual axes. The maximum coefficient of variation for displacement of unloaded axes was less than 0.5% for all axes. The expected and observed actual displacements had a high level of correlation with coefficients of determination of 1.0 for all axes. Conclusions: Given that this system can accurately simulate and track simple and complex motion, there is a new opportunity to study kinematics of the shoulder under normal and pathological conditions in a cadaveric shoulder model.

Background: Changes to the integrity of the acromioclavicular (AC) joint impact scapulothoracic and clavicular kinematics. AC ligaments provide anterior-posterior stability, while the coracoclavicular (CC) ligaments provide superior-inferior stability and a restraint to scapular internal rotation. The purpose of this cadaveric study was to describe the effect of sequential AC and CC sectioning on glenohumeral (GH) kinematics during abduction (ABD) of the arm. We hypothesized that complete AC ligament insult would result in altered GH translation in the anterior-posterior plane during abduction, while subsequent sectioning of both CC ligaments would result in an increasing inferior shift in GH translation. Methods: Six cadaveric shoulders were studied to evaluate the impact of sequential sectioning of AC and CC ligaments on GH kinematics throughout an abduction motion in the coronal plane. Following an examination of the baseline, uninjured kinematics, the AC ligaments were then sectioned sequentially: (1) Anterior, (2) Inferior, (3) Posterior, and (4) Superior. Continued sectioning of CC ligamentous structures followed: the (5) trapezoid and then the (6) conoid ligaments. For each group, the GH translation and the area under the curve (AUC) were measured during abduction using an intact cadaveric shoulder. Total translation was calculated for each condition between ABD 30° and ABD 150° using the distance formula, and a univariate analysis was used to compare total translation for each axis during the different conditions. Results: GH kinematics were not altered following sequential resection of the AC ligaments. Disruption of the trapezoid resulted in significant anterior and lateral displacement of the center of GH rotation. Sectioning the conoid ligament further increased the inferior shift in GH displacement. Conclusion: A combined injury of the AC and CC ligaments significantly alters GH kinematics during abduction. Type III AC separations, result in a significant change in the shoulder’s motion and may warrant surgical reconstruction to restore normal function.

Background: There remains controversy on the role of the deltoid on glenohumeral translations during basic and pitching motions. We thus studied the passive effect of the deltoid on the deltoid glenohumeral joint center (GHJC). Methods: Six shoulders were tested using an automated mechanical system. A baseline motion pattern of the intact specimen was contrasted with glenohumeral translation after removal of the deltoid. Each condition was evaluated in abduction (ABD) and an abbreviated throwing motion (ATM) using retro-reflective, bone-embedded markers. The absolute trajectory and the area under the curve (AUC) for each motion were calculated and glenohumeral kinematics with respect to the GH translation were compared. Results: The removal of the deltoid resulted in significant changes of the GH translation. During 30-60° of ABD, it resulted in a superior and more anterior GH translation, while in the 60-90° segment in a more inferior and medial GH translation. During 90-120°, the GH translation was medialized. In the pitching motion from maximum external rotation to 90° of external rotation (ER), the removal of the deltoid resulted in a more superior, anterior and lateral GH translation. Thus limits anterior translation in the abduction-external rotation position. In the remaining segments (90-80° and 80-45° of ER), it resulted in a lateralization of the GH translation. Conclusions: Modelling the throwing shoulder, the deltoid has a significant influence on glenohumeral motion. Athletes with deltoid dysfunction and limited range of motion are at risk for injury due to the resulting change in their throwing mechanics.

Background: High resolution μCT, and combined μPET/CT have emerged as non-invasive techniques to enhance or even replace dual energy X-ray absorptiometry (DXA) as the current preferred approach for fragility fracture risk assessment. The aim of this study was to assess the ability of µPET/CT imaging to differentiate changes in rat bone tissue density and microstructure induced by metabolic bone diseases more accurately than current available methods. Methods: Thirty three rats were divided into three groups of control, ovariectomy and vitamin-D deficiency. At the conclusion of the study, animals were subjected to glucose (18FDG) and sodium fluoride (Na18F) PET/CT scanning. Then, specimens were subjected to µCT imaging and tensile mechanical testing. Results: Compared to control, those allocated to ovariectomy and vitamin D deficiency groups showed 4% and 22% (significant) increase in 18FDG uptake values, respectively. DXA-based bone mineral density was higher in the vitamin D deficiency group when compared to the other groups (cortical bone), yet μCT-based apparent and mineral density results were not different between groups. DXA-based bone mineral density was lower in the ovariectomy group when compared to the other groups (cancellous bone); yet μCT-based mineral density results were not different between groups, and the μCT-based apparent density results were lower in the ovariectomy group compared to the other groups. Conclusion: PET and micro-CT provide an accurate three-dimensional measurement of the changes in bone tissue mineral density, as well as microstructure for cortical and cancellous bone and metabolic activity. As osteomalacia is characterized by impaired bone mineralization, the use of densitometric analyses may lead to misinterpretation of the condition as osteoporosis. In contrast, µCT alone and in combination with the PET component certainly provides an accurate three-dimensional measurement of the changes in both bone tissue mineral density, as well as microstructure for cortical and cancellous bone and metabolic activity.

Background: The shoulder has the greatest range of motion of any joint in the human body. This is due, in part, to the complex interplay between the glenohumeral (GH) joint and the scapulothoracic (ST) articulation. Currently, our ability to study shoulder kinematics is limited, because existing models isolate the GH joint and rely on manual manipulation to create motion, and have low reproducibility. Similarly, most established techniques track shoulder motion discontinuously with limited accuracy. Methods: To overcome these problems, we have designed a novel system in which the shoulder girdle is studied intact, incorporating both GH and ST motions. In this system, highly reproducible trajectories are created using a robotic actuator to control the intact shoulder girdle. High-speed cameras are employed to track retroreflective bone markers continuously. Results: We evaluated this automated system’s capacity to reproducibly capture GH translation in intact and pathologic shoulder conditions. A pair of shoulders (left and right) were tested during forward elevation at baseline, with a winged scapula, and after creation of a full thickness supraspinatus tear. Discussion The system detected differences in GH translations as small as 0.5 mm between different conditions. For each, three consecutive trials were performed and demonstrated high reproducibility and high precision.

Background: The purpose of this biomechanical study was to determine the effect of shortened clavicle malunion on the center of rotation of the glenohumeral (GH) joint, and the capacity of repair to restore baseline kinematics. Methods: Six shoulders underwent automated abduction (ABD) and abbreviated throwing motion (ATM) using a 7-DoF automated upper extremity testing system in combination with an infrared motion capture system to measure the center of rotation of the GH joint. ATM was defined as pure lateral abduction and late cocking phase to the end of acceleration. Torsos with intact clavicle underwent testing to establish baseline kinematics. Then, the clavicles were subjected to midshaft fracture followed by kinematics testing. The fractured clavicles underwent repairs first by clavicle length restoration with plate fixation, and then by wiring of fragments with a 2-cm overlap to simulate shortened malunion. Kinematic testing was conducted after each repair technique. Center of rotation of the GH joint was plotted across all axes to outline 3D motion trajectory and area under the curve. Results: Throughout ABD, malunion resulted in increased posterior and superior translation compared to baseline. Plate fixation restored posterior and superior translations at lower abduction angles but resulted in excess anterior and inferior translation at overhead angles. Throughout ATM, all conditions were significantly anterior and superior to baseline. Translation with malunion was situated anterior to the fractured and ORIF conditions at lower angles of external rotation. Plate fixation did not restore baseline anteroposterior or superoinferior translation at any angle measured. Conclusions: This study illustrates the complex interplay of the clavicle and the GH joint. While abnormal clavicle alignment alters shoulder motion, restoration of clavicle length does not necessarily restore GH kinematics to baseline. Rehabilitation of the injured shoulder must address the osseous injury and the dynamic forces of the shoulder girdle.

Bone fracture is a very common body injury. The healing process is physiologically complex, involving both biological and mechanical aspects. Following a fracture, cell migration, cell/tissue differentiation, tissue synthesis, and cytokine and growth factor release occur, regulated by the mechanical environment. Over the past decade, bone healing simulation and modeling has been employed to understand its details and mechanisms, to investigate specific clinical questions, and to design healing strategies. The goal of this effort is to review the history and the most recent work in bone healing simulations with an emphasis on both biological and mechanical properties. Therefore, we provide a brief review of the biology of bone fracture repair, followed by an outline of the key growth factors and mechanical factors influencing it. We then compare different methodologies of bone healing simulation, including conceptual modeling (qualitative modeling of bone healing to understand the general mechanisms), biological modeling (considering only the biological factors and processes), and mechanobiological modeling (considering both biological aspects and mechanical environment). Finally we evaluate different components and clinical applications of bone healing simulation such as mechanical stimuli, phases of bone healing, and angiogenesis.

Background: Anterior cruciate ligament (ACL) reconstruction is a widely accepted procedure; however, controversies exist about ACL augmentation. The purpose of this study was to assess the clinical outcomes of ACL augmentation in professional and amateur athletes with isolated single bundle ACL tears. Materials and methods A consecutive series of professional and amateur athletes with partial ACL tears who underwent selective bundle reconstruction were analyzed. Stability was assessed with the Lachman test, anterior-drawer test, pivot-shift test and KT-1000 arthrometer. Functional assessment was performed using the subjective Lysholm questionnaire. Results: Fifty-six patients were enrolled. The mean follow-up period was 19.3 months. All patients had posterolateral bundle (PLB) tears, and no anteromedial bundle (AMB) tears were found. The Lysholm score improved significantly from 78 (SD = 2.69) preoperatively to 96 (SD = 3.41) postoperatively (P value <0.0001). The pivot-shift test, Lachman test and anterior-drawer test results were negative in all cases postoperatively. Anterior tibial translation from neutral was 4.9 mm (SD = 2.7) preoperatively, and decreased significantly to 2.1 (SD = 0.6) postoperatively, measured with a KT-1000 arthrometer (P value <0.00001). Conclusion: In this study, we showed that ACL augmentation had good results in symptomatic professional and amateur athletes, and although further studies are needed to investigate long-term results, we recommend this surgery for all symptomatic athletic patients, especially those who would like to maintain an active lifestyle. Level of evidence IV.

Background: Shoulder pain is a common problem, with 30% to 50% of the American population affected annually. While the majority of these shoulder problems improve, there is a high rate of recurrence, as 54% of patients experience persistent symptoms 3 years after onset. Purpose: Posterior shoulder tightness has been shown to alter glenohumeral (GH) kinematics. Clinically, posterior shoulder contractures result in a significant loss of internal rotation and abduction (ABD). In this study, the effect of a posterior capsular contracture on GH kinematics was investigated using an intact cadaveric shoulder without violating the joint capsule or the rotator cuff. Study Design: Controlled laboratory study. Methods: Glenohumeral motion, humeral load, and subacromial contact pressure were measured in 6 fresh-frozen left shoulders during passive ABD from 60° to 100° using an automated robotic upper extremity testing system. Baseline values were compared with the experimental condition in which the full thickness of posterior tissues was plicated without decompressing the joint capsule. Results: Posterior soft tissue plication resulted in increased compression between the humeral head and the glenoid (axial load) at 90° of ABD. Throughout ABD, the posterior contracture increased the anterior and superior moment on the humeral head, but it did not change the GH kinematics in this intact model. As a result, there was no increase in the subacromial contact pressure during ABD with posterior plication. Conclusion: In an intact cadaveric shoulder, posterior contracture does not alter GH motion or subacromial contact pressure during passive ABD. By tightening the soft tissue envelope posteriorly, there is an increase in compressive load on the articular cartilage and anterior/superior force on the humeral head. These findings suggest that subacromial impingement in the setting of a posterior soft tissue contracture may result from alterations in scapulothoracic motion, not changes in GH kinematics. Clinical Relevance: This investigation demonstrates that posterior capsular plication increases the axial load on the shoulder joint during ABD. While a significant difference from baseline was observed in the plicated condition, posterior capsular plication did not change GH motion or subacromial contact pressure significantly.